by ErikSS » Thu Jun 06, 2013 10:14 pm
This is the best one I have. You basically take piece you cut out of the middle (that I marked), and cut the 1" flange off the top of it, and the sides cut at 90-degrees, at the point right after the angles start. This will give you the horizontal bottom piece, and it should end at the same point as the back of the top of the bumper. The rest is just making the angle pieces and welding them in and grinding them down.
Thanks Mike. I kinda figured and had a start on it. I'm effective but not proficient at making these little angle pieces. I love the quality of the bumper. I've made a couple mistakes, but I think the finished product is going to be awesome.
It's not how fast you go. It's how quick you get there.