by larryk » Mon Oct 24, 2016 1:37 pm
Why doesnt somebody just heat up the current ball joint pinch mount and rebend it to make it flatter? Seems to be a simple solution to the ball joint angle issue (not the adjustability one though). I just did the flip with poly bushings, and got it aligned this Saturday. With a 3" spacer lift, the EXT springs (as I *have* an EXT), and Billstein's.....I was able to get it right in spec on caster/camber/toe. The ball joint angle, while not perfectly upright, is well within the range of motion expected of them.
FWIW, the poly bushings are smooth as silk, quiet (so far) and allow a good range of articulation.