by bartonmd » Fri Jan 17, 2014 10:05 am
Ok, I'm thinking about with .035 wire, then, because I remember it being about the same wire speed for 3/8 and for 1/2, but the voltage was higher. It's all from memory though, because my 252 has juice to spare, so they go up pretty linearly. But yes, if you are on the hairy edge, lowering the wire speed actually lowers the current output, but makes the actual filler hotter, so it will penetrate better. Eta: More specifically, you adjust voltage with the dial, and the wire speed changes the current. More wire speed = more current. At the edge of a welders capability, it will usually have voltage but run out of current capacity, so you lower then wire speed in order to get the wire temperature hotter to penetrate deeper.