by ErikSS » Wed Jan 29, 2014 3:22 pm
If you go as small as a 12" pipe wrench you will probably want a cheater pipe. If you have then tight they require a pretty good pull to break loose. Since it is machined for a 2" wrench I can't imagine a pipe wrench wont grab it. The only time I worry is when the slot for the wrench is machined in a way the pipe wrench can't get to the hex.
Mike I bent a cheap Chinese TRE that I threw on before I knew better. Not a sleeved Moog.
It's not how fast you go. It's how quick you get there.