2" receiver install:
Find the center on the inside, trace the receiver, and cut it out either with a cutoff wheel or torch/plasma/whatever.



Grind paint or powder off of receiver

Tack it in, in the middle of the "top" on the front, at 3.25" from front of bumper to front of receiver, then square left to right, and tack the upper 2 corners, then go inside and tack it flat against the upper bumper mount.



Burn in the front

Burn in the back side, 1-layer all the way around, then do the 2nd and 3rd pass, for a nice big fillet to transfer stress better.


Then cut (2) pieces 3" x 2" and fillet or bevel 2 of the corners on the 3" sides, to clear the weld and bent edge.

Place them in like so, and weld all around

5" lights:
Place the cut tube pieces from me where you want them, and so that they look "forward" (not out to the sides) as shown, and trace inside and outside of the tube, then torch/plasma/jigsaw between the 2 lines. (this is something that I can cut out for you, for a nominal fee, if you don't have any of the above tools).




Put the tube in from the back so that it faces "forward" (long part toward the middle of the bumper), tack it in, then seam weld as shown.


Clean it up roughly with a grinder

Then with a flap disc

Then with a flap wheel on a die grinder, or a sanding drum on a Dremel, as I did the first couple (but a dremel is REALLY slow).

Next, the light mounts. Bolt the light mount tab to the light, then position the light as needed, and tack the mount in. Remove the light, and burn in the mount.



Then run a 4.5" flap disc around everything to smooth it all out, including the cut front edges of the shackle mounts, and you're good to go to paint.

