by v7guy » Sat Jun 11, 2016 12:01 am
There's been a few guys that have done the P12 swap, the unicorn is the 06 pcm from the I6 trucks, it still runs off of of serial data and is a P12 (the SS and 5.3 went to can-bus in 06 and the I6 trucks followed suit in 07). The early gauge cluster doesn't play well with the 06 pcm (fuel level, voltage etc is reversed... Reads full when empty for example, brake light stays on, etc) so it would need swapped, presumably an 06 cluster would work. The BCM apparently communicates just fine after the wires are moved... about a dozen if I remember correctly.
Swapping the entire engine harness minimizes greatly the repinning and you can pick em up for $100 give or take $25.
Oddly enough, I haven't seen any ABS codes with my 04 trailblazer yet and it's on 37s with 5.13 gears. I've had it up to about 35 or 40 so far... But I've never tried to tune anything on it and it's still programmed with stock tires and 3.42s.
All things in moderation, including moderation.
Some people never go crazy... what truly horrible lives they must lead