Seeing my TB is up for the winter and I found a local wheeler who does fab work who just moved up from Indy aera. I asked him if he would be willing to give me a hand with the skid plate.
He was able to come over Sunday and we got The Template accomplished.
The design is going to be different than the way Mike has his. Its going to bolt the same way Mikes does at the Oil Skid Plate. Then it will have a 20 Degree bend after 9" bolting to the Oil Skid. But instead of havin it bolt with the tow hooks we decided to bring it up and bolt to the front of the bumper. This might change due to the possiability of a tube bumper.
Tho whole design of the skid plate will be something like this:
Dimentions are 27"Width x 40"Length using 3/16" steel. Bolt Protectors, and holes allowing air to flow will be added. We are also going to add some supports in the skid for added strength. For a 5'x5' sheet of 3/16" steel is $150+tax. Sadly no local junyards keep anything project worthy... So he is goin to check places in Indy where he got most of his stell while living in Indy.
He metioned that he has talked to Kyle a few times when he was living in the Indy Area.