![Image](https://lh4.googleusercontent.com/--9LEW6Dnh88/TvoOYEld_cI/AAAAAAAAAo8/G3aLYSlQwY8/w720/Skidder%2BAssy.jpg)
Moderator: bartonmd
JamesDowning wrote:This should be a fun thread to follow. It'll be great seeing the idea go from abstract concept to fruition.
djthumper wrote:That is because you have Kyle to keep you busy
djthumper wrote:Wow, you do have a lot going on. Sounds like you need to take time off from work to get some work done.If I were closer I would come by and give you a hand getting some of that done.
bartonmd wrote:djthumper wrote:Wow, you do have a lot going on. Sounds like you need to take time off from work to get some work done.If I were closer I would come by and give you a hand getting some of that done.
That's stuff that I have done, already... The only one of the listed that isn't done yet is the 2" body lift winch bumper... The only firsts that I know are coming up are the tube and plate brush guard above, and the 3" body lift Envoy bumper...
Mike
Flying Monkey wrote:
OHHHHHHHHHHH what are we looking at as far as sliders. Im REALLY wanting a set and was goign to order a set of unwelded from ebay after first of year. But would rather buy from you
Skidder wrote:Mike,
What is the best way to share visuals ideas using your sketch? Do I need to save the image, then open it in a "paint"-like program, then save it a photo saving program?
Or is there a more simple way?