Hey everybody.... I'm new to ORTB and new to forums in general.
I've been on the outskirts of this site and can't believe the wealth of knowledge and info for our platform. Much respect to the off road founders and early pioneers of the 360s...
I'm looking short term for about 3-3.5" suspension lift and 32s. I've already purchased '87 springs (up from 83) for the front, tahoe springs for the rear and just ordered the 2.5" S.L. The truck has 160xxx on it, so HD shocks for the front, and hopefully Fox 2.0 for the rear, just want to do a little more reading. While she's apart, going to do ball joints too (already did both hub assemblies and one C.V. n seal).
I also tried my hand at a roof rack. I'm an electrician, and novice welder at best. I bent up some EMT rings, cut some vertical stanchions, welded a front air valance and sone vertical plates for lights... sprayed it with some black hammer finish Rusto and I think it's not too bad.