SteveTB03's Build - 1998 Grand Cherokee

[SteveTB03]

As I'm getting rid of the TB I figured it was time to put up a new build thread for the replacement vehicle... a 98' ZJ.

1998 Grand Cherokee

Engine: 5.2L V8
Front axle: Dana 30
Rear axle: Dana 44A
Transfer case: NP231

Suspension Modifications:
Daystar 1.75" lift spacer's

Exterior Modifications:
Rattle canned the whole Jeep
BFG A/T 33x12.50R15
15x8 5 on 4.5 3.75 BS

Engine Modifications:
Rebuilt top end

Interior Modifications:
Stock

Electrical Modifications:
POLK MM 651 & POLK MM6501 speakers
Kenwood 4 channel amp
Kenwood Excelon HU

Recovery Equipment:
None yet

[SteveTB03]

Well a few more updates to list here.

I finished puttting the 1.75" pucks in my ZJ and painting it flat black


Also installed a glasspack


I bought a NP231 to swap over into my ZJ to replace my NP249 it was from a 96' XJ. I'm getting it rebuilt and putting a SYE onto it.


Rugged ridge SYE


And when I bought the SYE the owner of Adam's Driveshaft had some used 4.5" skyjacker lift coils for my ZJ for only a measly 100$


Next up is some new front and rear adjustable trackbars, longer brakelines, longer shocks, new procomp 15x8 black steelies and some 33's - 35's, and a HP30. And of course some IROR or clayton longarms.

Total lift with the pucks and springs will be a little over 6"

[SteveTB03]

So I bought some new 33x12.50R15 BFG A/T with some pro comp black steelies.

I only have 1.75" of lift still.

[SteveTB03]

I went and installed my 4.5" springs the other night.