Offroad Trailblazers and Envoys

Axle Swap Driveshaft?

G80, GU6, GT4, GT5, WTF? This section is for gearing and driveline stuff.

by Cable810 » Fri Mar 01, 2013 12:19 pm

If this isn't in the right spot mods please move to appropriate spot. On to my question. I've been doing some reading in the chiltons manual on different things regaurding my upcoming axle swap. I was going through on how to remove the driveshaft and it said to make a reference mark on where the shaft attaches to the pinion flange. Well with swaping out the rear axle I will not have the mark on the flang. So how am I to know what is the right way to reconnect the driveshaft? Make sense?
The FIRST Solid Axle Swapped Trailblazer in Presque Isle County MI
My Build
The Roadie wrote:Research, plan your mods, fund the plan, then GO DO THEM. THEN WHEEL IT.
User avatar
Cable810
Veteran
 
Posts: 1989
Joined: Thu Feb 09, 2012 6:43 pm
Location: MI, Rogers City
Name: Caleb
Vehicle Year: 2002
Vehicle: Chevrolet TrailBlazer
DriveTrain: 4WD w/ Aftermarket Locker
Rank: Offroad Rated

by The Roadie » Fri Mar 01, 2013 12:29 pm

I just winged it. One way *might* have a bit less vibration after an axle swap, but offroading junk tends to vibrate on a good day, so I would not sweat it.
User avatar
The Roadie
Founder
 
Posts: 5011
Joined: Mon Sep 07, 2009 11:29 pm
Location: CA, Vista, San Diego County
Name: Bill Carton
Vehicle Year: 2004
Vehicle: GMC Envoy
DriveTrain: 4WD w/ G80
Rank: Expedition Guide

by HARDTRAILZ » Fri Mar 01, 2013 12:54 pm

You will never know where it would have been aigned, however I have never had an issue in the dozens of rearends I have swapped in vehicles over the years.
I hate to advocate weird chemicals, alcohol, violence or insanity to anyone...but
they've always worked for me.
User avatar
HARDTRAILZ
Moderator
 
Posts: 6342
Joined: Sat Sep 12, 2009 1:49 am
Location: IN, Batesville
Name: Kyle
Vehicle Year: 2006
Vehicle: Chevrolet TrailBlazer
DriveTrain: 4WD w/ Aftermarket Locker
Rank: Extreme Offroader

by v7guy » Fri Mar 01, 2013 1:06 pm

I've had the same experiences as Kyle, at worst I've rotated the drive shaft 180 to eliminate vibrations.
build thread

All things in moderation, including moderation.
Some people never go crazy... what truly horrible lives they must lead
User avatar
v7guy
Moderator
 
Posts: 3712
Joined: Wed Mar 09, 2011 10:17 pm
Location: NY, long island
Name: Jason
Vehicle Year: 2004
Vehicle: Chevrolet TrailBlazer
DriveTrain: 4WD
Rank: Offroad Rated

by fishsticks » Fri Mar 01, 2013 1:31 pm

+1...

Since there's no slip joint in the middle of our driveshafts (it's at the back of the t-case instead) it's really not an issue.
11 Silverado LTZ - 6.2L/6l80, 2/3 drop, self tuned
85 Hilux - 3RZ, dual cases, caged, 40s, chromo everything
02 TrailBlazer LTZ - 35s, lockers, balls - Gone but not forgotten - Build
User avatar
fishsticks
Moderator
 
Posts: 4356
Joined: Thu Apr 01, 2010 11:30 pm
Location: WA, Vancouver
Name: Donny
Vehicle Year: Other
Vehicle: Other Vehicle
DriveTrain: 4WD w/ Aftermarket Locker
Rank: Extreme Offroader

by Cable810 » Fri Mar 01, 2013 2:48 pm

Awsome! Thanks Guys!!
The FIRST Solid Axle Swapped Trailblazer in Presque Isle County MI
My Build
The Roadie wrote:Research, plan your mods, fund the plan, then GO DO THEM. THEN WHEEL IT.
User avatar
Cable810
Veteran
 
Posts: 1989
Joined: Thu Feb 09, 2012 6:43 pm
Location: MI, Rogers City
Name: Caleb
Vehicle Year: 2002
Vehicle: Chevrolet TrailBlazer
DriveTrain: 4WD w/ Aftermarket Locker
Rank: Offroad Rated

by Sugar16 » Fri Mar 01, 2013 5:35 pm

As long as your driveshaft is phased correctly it won't make a difference when you connect the flanges
User avatar
Sugar16
Off-Roader
 
Posts: 113
Joined: Mon Sep 24, 2012 6:06 pm
Location: OH, Canton
Name: Jonathan
Vehicle Year: 2004
Vehicle: GMC Envoy
DriveTrain: 4WD

by chevycrew » Fri Mar 01, 2013 7:58 pm

Yep, it don't matter, not sure why they even mention it.
User avatar
chevycrew
Veteran
 
Posts: 1088
Joined: Tue Mar 08, 2011 2:42 pm
Location: UT, Salt Lake City
Name: Steve
Vehicle Year: 2002
Vehicle: Chevrolet TrailBlazer
DriveTrain: 4WD
Rank: Trail Ready

by HARDTRAILZ » Sat Mar 02, 2013 3:13 am

Tequila
I hate to advocate weird chemicals, alcohol, violence or insanity to anyone...but
they've always worked for me.
User avatar
HARDTRAILZ
Moderator
 
Posts: 6342
Joined: Sat Sep 12, 2009 1:49 am
Location: IN, Batesville
Name: Kyle
Vehicle Year: 2006
Vehicle: Chevrolet TrailBlazer
DriveTrain: 4WD w/ Aftermarket Locker
Rank: Extreme Offroader

by v7guy » Sat Mar 02, 2013 9:22 am

whiskey
build thread

All things in moderation, including moderation.
Some people never go crazy... what truly horrible lives they must lead
User avatar
v7guy
Moderator
 
Posts: 3712
Joined: Wed Mar 09, 2011 10:17 pm
Location: NY, long island
Name: Jason
Vehicle Year: 2004
Vehicle: Chevrolet TrailBlazer
DriveTrain: 4WD
Rank: Offroad Rated

by Cable810 » Sat Mar 02, 2013 9:38 am

Rye Wiskey haha!?!?!?
The FIRST Solid Axle Swapped Trailblazer in Presque Isle County MI
My Build
The Roadie wrote:Research, plan your mods, fund the plan, then GO DO THEM. THEN WHEEL IT.
User avatar
Cable810
Veteran
 
Posts: 1989
Joined: Thu Feb 09, 2012 6:43 pm
Location: MI, Rogers City
Name: Caleb
Vehicle Year: 2002
Vehicle: Chevrolet TrailBlazer
DriveTrain: 4WD w/ Aftermarket Locker
Rank: Offroad Rated

by v7guy » Sat Mar 02, 2013 1:56 pm

Cable810 wrote:Rye Wiskey haha!?!?!?


c'mon now, you're worth at least some Wathens bourbon aren't you? I know Kyle is.
build thread

All things in moderation, including moderation.
Some people never go crazy... what truly horrible lives they must lead
User avatar
v7guy
Moderator
 
Posts: 3712
Joined: Wed Mar 09, 2011 10:17 pm
Location: NY, long island
Name: Jason
Vehicle Year: 2004
Vehicle: Chevrolet TrailBlazer
DriveTrain: 4WD
Rank: Offroad Rated

by Cable810 » Sat Mar 02, 2013 7:34 pm

It was the first thing that came to my mind haha. I don't even know what Wathens bourbon is Kinda got off topic....
The FIRST Solid Axle Swapped Trailblazer in Presque Isle County MI
My Build
The Roadie wrote:Research, plan your mods, fund the plan, then GO DO THEM. THEN WHEEL IT.
User avatar
Cable810
Veteran
 
Posts: 1989
Joined: Thu Feb 09, 2012 6:43 pm
Location: MI, Rogers City
Name: Caleb
Vehicle Year: 2002
Vehicle: Chevrolet TrailBlazer
DriveTrain: 4WD w/ Aftermarket Locker
Rank: Offroad Rated

by HARDTRAILZ » Sat Mar 02, 2013 9:45 pm

Crown tonight
I hate to advocate weird chemicals, alcohol, violence or insanity to anyone...but
they've always worked for me.
User avatar
HARDTRAILZ
Moderator
 
Posts: 6342
Joined: Sat Sep 12, 2009 1:49 am
Location: IN, Batesville
Name: Kyle
Vehicle Year: 2006
Vehicle: Chevrolet TrailBlazer
DriveTrain: 4WD w/ Aftermarket Locker
Rank: Extreme Offroader

by fishsticks » Sat Mar 02, 2013 9:50 pm

HARDTRAILZ wrote:Crown tonight



Crown every night.
11 Silverado LTZ - 6.2L/6l80, 2/3 drop, self tuned
85 Hilux - 3RZ, dual cases, caged, 40s, chromo everything
02 TrailBlazer LTZ - 35s, lockers, balls - Gone but not forgotten - Build
User avatar
fishsticks
Moderator
 
Posts: 4356
Joined: Thu Apr 01, 2010 11:30 pm
Location: WA, Vancouver
Name: Donny
Vehicle Year: Other
Vehicle: Other Vehicle
DriveTrain: 4WD w/ Aftermarket Locker
Rank: Extreme Offroader

by v7guy » Sun Mar 03, 2013 3:44 am

I don't even call it a hangover anymore, it's just "waking up" :friday:
build thread

All things in moderation, including moderation.
Some people never go crazy... what truly horrible lives they must lead
User avatar
v7guy
Moderator
 
Posts: 3712
Joined: Wed Mar 09, 2011 10:17 pm
Location: NY, long island
Name: Jason
Vehicle Year: 2004
Vehicle: Chevrolet TrailBlazer
DriveTrain: 4WD
Rank: Offroad Rated


Return to Differentials / Axles