by jdmser » Fri Mar 13, 2015 6:02 pm
A while ago I started to hear what I thought was a wheel bearing noise on the drivers side so I replaced it. I also replaced the cv shaft while I was in there because the inner boot had a tear. The noise was better but, not gone. I noticed the diff had a wet spot under the seal so I replaced the inner axle bearing and seal today. Again the noise was better but, not gone. While it was jacked up I started to spin the tire while listening for noise. That's when I noticed the diff moving. As I spun the tire one full revolution the diff/engine would move about an 1/8" in one direction and then the other. I would imagine bad motor mounts but, I haven't noticed any engine shake. Any thoughts?