by Cable810 » Tue Sep 17, 2013 10:41 am
I'd rather it not have the gangster lean. Well I got some measurements today and they go as followed. If I was to remove the front sway bar end links I'd have to cut them off. They look to be in good shape. I did notice that the cross tube under the axle is bent a little but not much. I don't see how that could throw the body off. I took it to she shop behind my house and he was stumped and didn't know even what to say. The last time I did anything was when I took the doors off and flexed it... wondering If I flexed it enough to throw something outta whack.
Left Side:
Read Fender 36 3/4"
Front Fender 36 7/8"
Right Side:
Rear Fender 37 7/8"
Front Fender 37 3/4"
Axle From the outside of the diff housing both sides:
13 5/8"
Frame:
Rear by bolts for rear bumper:
25 1/4" both left and right side
bout the middle of the frame 12 1/2" both sides
Front of Frame by bumper was 21 1/4"
All measurements were to the bottom of frame, fender, and axle.
The
FIRST Solid Axle Swapped Trailblazer in Presque Isle County MI
My
BuildThe Roadie wrote:Research, plan your mods, fund the plan, then GO DO THEM. THEN WHEEL IT.