? regarding washers for z71 shocks

[Philberto]

Hey again,

I was wondering if anybody could give me the ID of the washers they used to space the z71 shocks on the lower perch. I know it needs to have 3/4" of space taken up, but can't take the bolt out to measure it right now, and need to pick up the washers on the way home.

Thanks in advance,

Philip

[Trail X]

#17 listed as: BOLT,M21X1.75X105,36 THD(RR S/ABS)

So 21mm mininum ID for the washers. (Thats 0.82in... so 7/8" ID should work fine.) But I didn't actually measure one. So take it as you will.

[Philberto]

Thanks, I just looked there, but I noticed that the diameter for the bolt is incorrectly listed as 21mm... The bolt head is 19mm, and the nut is listed as 12mm diameter, so I'm thinking compnine mixed up the numbers. Thanks for the help though.

[Trail X]

Hmm, M21 does seem large now that I actually think about it... good point! Glad you used your noggin!