by AGENT SMITH » Sun Oct 12, 2014 6:34 pm
Hey, I finally got it! I used a combination of all the things I had tried separately plus what you guys had suggested. Wasn't perfect, but got it to move enough to wiggle and tap the retaining bolt through. What I did was clean up the bj pins really well, then placed the uca on. I put a c clamp around the whole thing to tighten them together as I worked. I used the chisel in the middle to spread it and sprayed it all down with pb blaster and beat down on the uca, all while continually tightening the c clamp. After a while of that and taking the chisel out occasionally to check with the bolt, I got it through. I was so close to getting out the drill bits, but my persistence payed off. Thanks for all the feedback, hopefully this thread will help somebody else who might have a real difficult time getting that connection made like I did.